How to become a QNAP SSH admin
After login into your QNAP server through the SSH, you may find that despite using an admin account, you are
QO-100 Bullseye LNB Integrated 3d Printed Holder
Project: M0PPR QO-100 Bullseye integrated antenna Please note I do not take any responsibility for this project, you do it
Continue readingQO-100 Bullseye LNB Integrated 3d Printed Holder
Raspberry Pi 5 – sudo apt install -y libqt5serialport5-dev command does not work
I hope this short post will help anybody who is looking to resolve that particular problem on Raspberry Pi 5.
Continue readingRaspberry Pi 5 – sudo apt install -y libqt5serialport5-dev command does not work
739MHz Helical Filter for QO-100
The small introduction. I am radio amateur operator transmitting signals at 2.4GHz band into the geostationary amateur satellite QO-100. I
Icom IC-9700 frequency modification
I hate Icom IC-9700 for that. They blocked not only transmitting (which is fine) but also receiving anything outside ham
2.4GHz Cavity Filter
The small introduction. I am radio amateur operator transmitting signals at 2.4GHz band into the geostationary amateur satellite QO-100. I
How to modify Bulls Eye LNB to inject 25MHz signal.
I am not going to explain basics – if you are here you probably know why I do it. So,
Continue readingHow to modify Bulls Eye LNB to inject 25MHz signal.
Adalm Pluto Rev C Hacks – how to extend frequency range, add GPS DO and add RX2 and TX2
Disclaimer: I do not take any responsibility in case something goes wrong with your device. There is a small chance
Leo Bodnar GPS DO 3D Model
When I do my mechanical and electronic radio (and not only) projects, I always try to design everything in Solidworks,
How to add external antenna to your WiFi router
This mod is based on the TP-Link Archer AX53 (AX3000 Gigabit WiFi 6), however it will be very similar if
Continue readingHow to add external antenna to your WiFi router